To provide for single family residential development and compatible uses on lots in higher density multi-lot country residential subdivisions located within the Country Residential Area Concept Plan and in accordance with an adopted Area Structure Plan.
Subject to any fundamental use criteria for certain uses set out below, the permitted uses and the discretionary uses for this zone are listed in Table 12.19(A).
Permitted uses
Discretionary uses
Bed and breakfast*
Deleted (Bylaw 45-2024)
Deleted (Bylaw 51-2024)
Home business minor*
Residential sales centre*
Deleted (Bylaw 39-2024)
Single dwelling
The following uses shall only be considered in this zone if they meet the associated criteria below:
Subdivision must comply with Table 12.19(B).
Table 12.19(B) Subdivision Regulations
Subsection
Regulation
Measurement
(a)
Minimum lot width
25.0 m
(b)
Minimum lot width of an irregularly shaped lot (e.g., a pie lot) fronting onto an internal subdivision road
20.0 m
(c)
Minimum lot area
0.125 ha
(d)
Maximum lot area
0.4 ha
Development must comply with Table 12.19(C), Table 12.19(D) and Table 12.19(E).
Table 12.19(C) Development Regulations: Principal Building
Height
Maximum height
10.0 m
Minimum setbacks
From a lot line abutting a rural road
30.0 m
From a front lot line
7.0 m
From a side lot line
4.0 m
(e)
From a lot line abutting a flanking internal subdivision road
(f)
From a rear lot line
Table 12.19(D) Development Regulations: Accessory Buildings and Accessory Structures
6.7 m
3.0 m
Maximum ground floor area
Of a single accessory building
68 m2
Of all accessory buildings combined
94 m2
Additional regulations
(g)
An accessory building or accessory structure shall not be located in a front yard.
(h)
All accessory buildings shall complement the principal dwelling with respect to design, colour, and exterior finish to the satisfaction of the Development Officer.
Table 12.19(E) Development Regulations: Site Coverage
Maximum site coverage
40%
Last updated: Monday, June 16, 2025 Page ID: 51980